16 ohms, 20 Hz to 20 kHz,0.1% THD, 400 watts
16 ohms, 1kHz, 1% THD, 425 watts
8 ohms, 20 Hz to 20 kHz, 0.1% THD, 650 watts
8 ohms, 1 kHz, 1% THD, 725 watts
4 ohms, 1 kHz, 1% THD, 1000 watts
OUTPUT POWER (BRIDGED MONO)
16 ohms, 20 Hz to 20 kHz,0.1% THD, 1300 watts
8 ohms, 1 kHz, 1% THD, 2000 watts
DISTORTION (SMPTE-IM): less than 0.05%
DISTORTION (TYPICAL): less than 0.01% THD
4Ω to 8Ω:
20 Hz–20 kHz, 10 dB below rated power
1.0 kHz and below, full rated power
FREQUENCY RESPONSE:
20 Hz to 20 kHz, ±0.15 dB
5 Hz to 60 kHz, +0/-3 dB
DAMPING FACTOR:
Greater than 350
DYNAMIC HEADROOM: 3.0 dB at 4 ohms
NOISE: 108 dB below rated output (20 Hz to 20 kHz)
SENSITIVITY: 1.16 Vrms for rated power (8 ohms)
VOLTAGE GAIN: 63 (36 dB)
INPUT IMPEDANCE: 10K unbalanced, 20K balanced
CONTROLS:
Front: AC Switch, Ch 1 and Ch 2 Gain Knobs, Ch 1 and Ch 2 Clip Limiter Switches
Back: Parallel/Stereo/Bridge Switch, Remote Power Supply Enable Terminal
INDICATORS:
PROT: Red LED CLIP: Red LED, 1 per channel
STANDBY: Yellow LED LEVEL -10: Yellow LED, 1 per channel
PWR-ON: Green LED LEVEL -20: Yellow LED, 1 per channel
SIG-PRESENT: Green LED, 1 per channel
CONNECTORS: (each channel)
Input: Barrier strip and Neutrik “Combo” XLR and ¼” input.
Speakers: “Touch proof” binding posts.
Data port: HD 15 female
COOLING: Dual variable speed fans, rear-to-front air flow.
AMPLIFIER PROTECTION:
Full short circuit†, open circuit, thermal muting, ultrasonic, and RF protection.
Stable into reactive or mismatched loads.
LOAD PROTECTION:
On/off muting. DC-fault protection.
OUTPUT CIRCUIT TYPE:
Complementary linear outputs. 2-step high efficiency circuit.
POWER REQUIREMENTS: 120, 230 VAC, 50–60 Hz