Se livreaza prin curier / posta sau se poate ridica local din Bucuresti

Se ofera la cerere manual in format electronic

Explicatii Youtube + demo: youtube.com/watch?v=p9u8lrsRrWE

Specificatii:
• Tensiune de alimentare intre 6V si 30V (adica 9V, 12V, 18V, 20V ,24V, 28V . . . . ) sau doar alimentat pe USB la 5V
• Capacitate maxima sarcina releu : max 10A AC DC
• Tensiune functie TRIGGER 4-20V dc
• Domeniul de reglare 0,1 sec – 999 minute

Product manual:
Working voltage: DC6V-DC30V (wide voltage anti-connection protection)
Trigger signal source: high-level trigger DC 3.0V—24V signal ground and system ground to improve the system's anti-interference ability can also short-circuit the ground
Output capacity: controllable DC 30V/10A or AC 250V/10A equipment
Mounting hole: diameter 3mm
Product size: 64mm*35mm*19.3mm
Working temperature: -40 C ~ 85 C

Operating mode:
P1 mode: After the signal is triggered, the relay turns on the OP time, then turns off; in the OP time, the following operation
P1.1: The signal is triggered again.
P1.2: Signal triggers re-timed again
P1.3: The signal triggers reset again, the relay is disconnected, and the timing is stopped.
P-2: Give the trigger signal, after the relay turns off the CL time, the relay turns on the OP time. After the timing is completed, the relay is turned off .
P3.1: Give the trigger signal, after the relay turns on the OP time, the relay turns off the CL time, then loops the above action, the signal is given again in the cycle, the relay is disconnected, the timing is stopped; the number of cycles (LOP) can be set
P3.2: No trigger signal is required after power-on, the relay turns on OP time, the relay turns off CL time, and the above actions are cycled; the number of cycles (LOP) can be set
P-4: Signal hold function If there is a trigger signal, the timing is cleared, the relay remains on; when the signal disappears, the relay is turned off after timing the OP ;

Relay enable mode:
ON : The relay is allowed to conduct during the OP conduction time.
OFF : The relay is prohibited from being turned on and is always off .
Short press the STOP button on the main interface to switch between ON and OFF. The current state will flash, then return to the main interface. This function is the emergency stop function, one button to open and close the relay.
Sleep mode ( long press the stop button to view the current mode ):
C-P sleep mode: within five minutes, without any operation, the digital tube automatically turns off the display, the program runs normally