QuinLed DIG OCTA Power Board 5 WLED ESP32 Arduino

QuinLED-Dig-Octa System
Power-5
Specifications
Lots of projects need power, especially LEDs! For this I have designed several powerboards which can be used to distribute and safely use the required power.

Design Goal
The power-5 is built around 12x 5.08mm pluggable output terminals divided over 2 sides. The power-5 in the series of powerboards has been specifically designed to allow for a stackable form factor which means that all output ports and fuses can still be reached even when multiple powerboards are stacked on top of each other.

All input and output terminals are equipped with individual fuse sockets allowing you to select the individual value fuse per output terminal.

The normal version of the power-5 has 3x 9.5mm barrier terminal blocks for input of power allowing for connecting up to 3x parallel wires from a single power supply to minimize voltage drop between the power supply and the powerboard.

Advised Power Supply
This board is ideally suited to be used with a Meanwell LRS-350-5 (60Amps at 5v) or LRS-600-12 (50Amps at 12v) power supply.

*Connecting multiple power supplies to a single powerboard is not allowed, if you wish to use multiple power supplies (even with different voltages) this is allowed within a stack so will require multiple boards.

Specifications
3x 9.5mm “barrier block” input terminals for both positive and negative
Allows power input wires using
Bare wire
Also when soldered (not recommended)
Wires with crimped on wire ferrules
Wires with crimped on fork style crimps (preferred)
With the right style fork crimps allows for up 3x 6AWG input wires
Board recommended max 50Amp continuous load total
Fore more detailed power handling rules please see the following article
12x 5.08mm pluggable output terminals
Allows up to 14AWG/2.0mm2 cable with ferrule
Has both + and – on single connector
Fuse socket per output
Max 10Amps fuse recommended
5v-24v capable
“Broken Fuse” light per output
Custom independent “constant brightness” circuit
Onboard capacitors
Features 2x 1500uF 35v big capacitors
Smooths high transient loads and voltage spikes
Per output 1uF 50v capacitor
Provides noise filtering on output ports
Onboard Voltage display
Shows actual voltage including potential voltage drop
Easy to identify voltage of powerboard in a mixed voltage stack!
4x M3 mounting holes
Connected to GND
Specials
Equipped with QPowerPost feature
Allows sharing power from powerboard to brainboard stack
Output only
Fully protected (Max 1.5Amps out, PTC auto-reset fuse)
5x M2.5 screw holes
Outer 4x GND
Inner 1x VCC
Extra 1x 5.08mm pluggable terminal
Provides VCC and GND out
Protected against input and max 1.5Amps (PTC auto-reset fuse) current
Ideal for hooking up brainboard if you do not wish to use QPowerPost