OpenIPC AIO "Mario" v1.0

Specifications

Ultra-small 16 layer pcb board size 30mm x 32mm (which blows the side covered with gold)
Main board has 4 x M2 mount holes and distance between hole centers 25.5mm x 25.5mm
Main board weight - 9.86 g, radiator weight - 7.36 g, fan weight - 5.37
The main processor of the system is SigmaStar SSC338Q, the WiFi chip is RTL8812AU and 16M NOR flash
Built-in Inertial Measurement Unit (IMU) for user applications working with a gyroscope and accelerometer
Built-in waterproof I2S high quality microphone (installed, but not yet activated in the firmware)
Onboard dual-way BEC supporting 2S-6S (7,4V-24V) power supply
150mm MIPI cable to connect the sensor to the main board
IMX335 sensor (14x14mm) with a 150° Field of View (FOV) M8 lens
New colorful camera case, color is random
Dual-band RF output with onboard 30dBm x2 power amplifiers for the 5G band
Two dual-band antennas, dipoles with 6 dBi gain and 130mm cable included
GH1.25 connector with a 100mm cable for direct flight controller telemetry communication
Interface connector for connecting an LWIR sensor or using it for SPI/I2C/PWM/GPIO
USB Type-C port for debug and settings, with built-in Ethernet output (CDC-Ether, RNDIS)
Onboard SD card for video recording and system updates
Integrated heat sink with 20mm x 20mm mount holes and cooling fan
On the side surface of the main board there is a laser engraving "This is original device from OpenIPC"
Very easy automatic firmware update from SD card
Default use 1,4090 bitrate in Majestic and WFB-NG configurations

Set contents in box

OpenIPC AIO "Mario" 30mm x 32mm board with heat sink & fan
Board 14mm x 14mm Sony IMX335 sensor with lens 151 FOV, case color is random
MIPI cable 150mm
GH1.25 6 pin power & UART cable
Two 3dBi antenna
100W Type-C cable, color random (green, gray, blue)
OpenIPC plastic tag
OpenIPC aluminum tag, 30mm diameter