Amplificator Crown Amcron Macro-tech 2401

Specifications

Macro-Tech 2400

Stereo mode (both channels driven):
1050 watts into 2 ohms.
800 watts into 4 ohms.
520 watts into 8 ohms.

Bridge-Mono mode:
2070 watts into 4 ohms.
1585 watts into 8 ohms.
1035 watts into 16 ohms.

Parallel-Mono mode:
2080 watts into 1 ohm.
1605 watts into 2 ohms.
1035 watts into 4 ohms

The following applies to units in Stereo mode with 8-ohm loads and
an input sensitivity of 26 dB gain unless otherwise specified.
Standard 1 kHz Power: refers to maximum average power in
watts at 1 kHz with 0.1% THD.
Full Bandwidth Power: refers to maximum average power in
watts from 20 Hz to 20 kHz with 0.1% THD.
120 VAC, 60 Hz Units: refers to amplifiers with dedicated transformers for 120 VAC, 60 Hz power mains.
International Units: refers to amplifiers with special multi-tap
transformers that are configurable for several AC mains voltages
and line frequencies (some are labeled 601, 1201 and 2401).
Performance
Frequency Response: ±0.1 dB from 20 Hz to 20 kHz at 1
watt
Phase Response: ±10 degrees from 10 Hz to 20 kHz at 1
watt
Signal-to-Noise Ratio: 20 Hz to 20 kHz: Better than
100 dB below full bandwidth power. A-weighted: Better
than 105 dB below full bandwidth power.
Total Harmonic Distortion (THD): Less than 0.05% at
full bandwidth power from 20 Hz to 1 kHz increasing linearly to 0.1% at 20 kHz.
Intermodulation Distortion (IMD): (60 Hz, 7 kHz) Less
than 0.05% from 163 milliwatts to full bandwidth power.
Damping Factor: Greater than 1,000 from 10 Hz to 400Hz
Slew Rate: Greater than 13 volts per microsecond.
Voltage Gain: 20:1 ±3% or 26 dB ±0.25 dB at the maximum level setting